Custom Hard Night Teeth Grinding Guard

Our hard night guards are created from 1mm thin layer of
hard laminate material. This device is designed for light teeth grinding or
individuals looking for a less bulky solution. Your custom night guard will be
created in our own dental office by a full time laboratory technician with 15+
years experience. The entire operation is under the direct supervision of a
dentist with over 30 years in the practice. You can be assured you will receive
a professionally manufactured product.
With your order you will receive:
1 Set of impression material (Part A & B)
1 Adjustable impression tray
1 Return bag
1 Instruction pamphlet
1 Return form
1 Prepaid postage return label (domestic orders only)
To Create Impression:
Adjust the dental tray to the size of your mouth. The tray can be used on the
upper or lower teeth.
The tray can be made smaller by snapping off a section(s) of the plastic
in the rear of the impression tray.
Vigorously mix both parts (A & B) of impression material together
Roll
into a 4 to 5 inch tube.
Place impression material uniformly into the tray and firmly push onto
your teeth.
It will take about 4 minutes for the material to fully harden.
Remove tray in a single motion, by pulling either up or down.
Rinse tray and seal in enclosed bag.
Complete form and wait 2 weeks to allow your guard to be created.

Leave a comment

Your email address will not be published.


*